Step by step including pictures on how to store Wire Trace Rigs on the Mirafont Leader & Rig Holder.

Step 1

Above Wire Trace Rig.

Step 2

Place the locking pin provided through the eye of the swivel.

Step 3

Wind the trace in the groove two times.

Step 4

Remove the locking pin, return to original position for re-use, move the swivel into the same groove as the trace, continue to wind the remainder of the trace allowing it to go over the swivel.

Step 5

Use pin provided to lock the trace in by pushing it through the eye of the swivel on a slight angle until the head of the pin reaches the swivel, remembering to place the swivel on the raised section to the right of the grove that the trace has been wound on.

Step 6

Repeat the above steps to fill the Leader & Rig Holder.

Step 7

When a Trace is required simply remove the locking pin, return to original position for re-use and unwind and it is free to be used.

Final tip

Always label your Leader & Rig Holders with a texta or a biro for easy identification.
You will be able to tell at a glance which rigs need replacing.